BUT I had to use a fine rasp to carefully remove some of the hard rubber at the front of the comb of the buttstock so the cocker could slide into place - it slides in and fits perfectly now. I had to buy two 1 1/2" 10x24 cap screws because the ones provided were too short for my bow - then the mounting bracket fit nicely and absolutely snugly. But the Bear video about this cocker said it would fit all the X model bows.well almost. Read more The tech rep at Bear archery told me they did not have a crank cocker for my crossbow - a Bear X Trek 380. Second issue - the sled was just a bit too narrow to fit over the rail on this bow - again, very gingerly and gradually widened the opening on the bottom of the sled until it would fit onto the rail - being very careful not to weaken the hooks that. The tech rep at Bear archery told me they did not have a crank cocker for my crossbow - a Bear X Trek 380.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |